Disk Brake Pressure Setting - Dürkopp Adler 52 i Series Service Instructions Manual

Puller

10.8 Disk brake pressure setting

Proper setting
The spring is to be pressed to the value of 17 mm.
Pic. 49: Disk brake pressure setting
(1) - Fastening screws
(2) - Setting ring
1. Loosen two fastening screws (1) of the setting ring (2).
2. The setting ring should be able to freely move on the shaft.
3. Press the spring (3) with the setting ring (2) to the brake disc (4) to the
4. Tighten two fastening screws (1).
Service Instructions 52Xi, 52Xi-75 - 00.0 - 11/2021
value of 7 mm.
17 mm
(3) - Spring
(4) - Brake disc
①
②
③
④
61