Puller
10.5 Puller pressure
Proper setting
The puller pressure must be adjusted to the sewn material.
Important
If the pressure was re-set, then the upper end position must be set anew!
( p. 54)
Pic. 44: Puller pressure
(1) - Pneumatic cylinder
1. Loosen the screw (2).
2. Shift the pneumatic cylinder (1):
3. Tighten the screw (2).
Service Instructions 52Xi, 52Xi-75 - 00.0 - 11/2021
①
②
• In the arrow direction (A) – the pressure is reduced
• In the arrow direction (B) – the pressure is increased
(2) - Screw
57