CYBEX Ion Series Assembly Instructions Manual page 22

4. Place threaded cap onto the shaft of the left upper work arm assembly.
5. Repeat Steps 1-4 to install the right upper work arm assembly
6. Route one end of the cable into the right cam assembly.
7. Install cable retainer securing the cable to the right cam assembly.
8. Install screws, washers, and locknuts securing the cable retainer cover plate to right cam assembly using an 8mm Allen wrench
and a 17mm wrench.
NOTE: Make sure the work arm is engaged in detent position "3" to easily access the screws.
Item
1
2
3
4
5
6
7
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Page 20 of 34
Description
Cable
Cam Assembly, Right
Cable Retainer
Cable Retainer Cover Plate
Screw, M10 x 1.5, 50mm
Washer, Flat 3/8"
Nut, M10 x 1.5, Hex Nylock
Qty.
1
1
1
1
2
2
2