Assembly Procedure - CYBEX Ion Series Assembly Instructions Manual

Assembly Procedure

Assemble Frame Components
1. Install screws and washers securing the front support leg to the tower frame using an 8 mm Allen wrench.
2. Install screws and washers securing the rear support leg to the tower frame using an 8 mm Allen wrench.
3. Install screws and washers securing the seat frame assembly to the tower frame using an 8mm Allen wrench.
4. Pull detent pin out and slide seat post assembly down into main frame.
TIP: Break-Free CLP can be used to lubricate the seat post assembly. Spray Break-Free CLP, or apply with a cloth, to the plated
seat post.
Item
1
2
3
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Item
1
2
3
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Item
1
2
3
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Page 11 of 34
Description
Support Leg, Front
Washer, Flat 3/8"
Screw, M10 x 1.5, 25 mm
Description
Support Leg, Rear
Washer, Flat 3/8"
Screw, M10 x 1.5, 25 mm
Description
Seat Frame Assembly
Screw, M10 x 1.5, 25mm
Washer, Flat 3/8"
Qty.
1
3
3
Qty.
1
3
3
Qty.
1
8
8