CYBEX Ion Series Assembly Instructions Manual page 25

15. Install screws, washers, and pivot shaft securing the left lower work arm assembly to the left upper work arm assembly using a
7mm Allen wrench.
16. Repeat Step 15 to install the right lower work arm assembly to the right upper work arm assembly.
Install Front Shrouds
1. Set front shrouds into the grooves on the bottom cap and then flex them into place in the top cap.
2. Press front shrouds in behind the shroud retainer grommets.
Item
1 Lower Work Arm Assembly, Left
2 Upper Work Arm Assembly, Left
3
4
5 Screw, M10 x 1.5, 25mm, Low Head with Loctite
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Item
1
2
Page 23 of 34
Description
Pivot Shaft
Washer, .375"
Description
Front Shroud, Left
Front Shroud, Right
Qty.
1
1
1
2
2
Qty.
1
1