CYBEX Ion Series Assembly Instructions Manual page 24

12. Install screws, washers, and locknuts securing the cable retainer cover plate to left cam assembly using an 8mm Allen wrench and
a 17mm wrench.
NOTE: Make sure the work arm is engaged in detent position "3" to easily access the screws.
13. Place pulley into the loop of the cable and pull it down into the head plate pulley bracket.
14. Install screw, washers, and locknut securing the pulley and routed cable to the head plate pulley bracket using an 8mm Allen
wrench and a 17mm wrench.
Item
1
2
3
4
5
6
7
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Item
1
2
3
4
5
6
Tighten hardware to 8-10 ft-lb (10.8-13.5 Nm).
Page 22 of 34
Description
Cable
Cam Assembly, Left
Cable Retainer
Cable Retainer Cover Plate
Screw, M10 x 1.5, 50mm
Washer, Flat 3/8"
Nut, M10 x 1.5, Hex Nylock
Description
Cable
Pulley, 3.5" OD
Head Plate Pulley Bracket
Screw, M10 x 1.5, 50mm
Washer, Flat 3/8"
Nut, M10 x 1.5, Hex Nylock
Qty.
1
1
1
1
2
2
2
Qty.
1
1
1
1
1
1