CYBEX Ion Series Assembly Instructions Manual page 17

7. Install screws and washers securing the bottom cap to the bottom of the tower frame using an 8mm Allen wrench.
8. Install screws and shroud retainer grommets into the side tubes of the tower frame using a Phillips screwdriver.
9. Slide weight stack cushions onto the guide rods.
Item
1
2
3
Tighten hardware to 8-10 ft-lb (10.8-13.5 Nm).
Item
1
2
Tighten hardware to 10-13 in-lb (1.1-1.5 Nm).
Page 15 of 34
Description
Bottom Cap
Screw, M10 x 1.5, 20mm
Washer, Flat 3/8"
Description
Grommet, Shroud Retainer
Screw, M4.2 x 0.7, Phillips
Qty.
1
2
2
Qty.
6
6