CYBEX Ion Series Assembly Instructions Manual page 20

15. Select either the LBS or KG weight stack label. Remove backing from label and apply to weight stack.
NOTE: One weight stack label sheet, LBS or KG, is used for both weight stacks.
16. Install screws securing the front cap to the tower frame using a 10mm socket wrench and ratchet.
NOTE: Screw heads can be accessed from the top or bottom.
17. Press grommets into holes at the top of the tower frame.
18. Install screws securing the tube caps to the tower frame using a Phillips screwdriver.
19. Press top cap down into the holes at the top of the tower frame.
Item
1
2
Item
1
2
Tighten hardware to 10-13 in-lb (1.1-1.5 Nm).
Item
1
2
3
4
Tighten hardware to 10-13 in-lb (1.1-1.5 Nm).
Page 18 of 34
Description
Weight Stack Label
Weight Stack
Description
Front Cap
Screw, M6, HCS, 50mm
Description
Top Cap
Tube Cap
Screw, 8 x ¾", Phillips
Grommet
Qty.
1
1
Qty.
1
4
Qty.
1
2
1
1