CYBEX Ion Series Assembly Instructions Manual page 16

3. Thread increment weight guide rods into the bottom plate of the tower frame. Tighten using a crescent wrench.
4. Install nuts and washers securing the increment weight guide rods to the top plate of the tower frame using a 7/16" wrench.
5. Flex rear shroud into position inside the tower frame.
6. Starting at the top, press the shroud retainers into the rear shroud securing it to the tower frame.
Item
1
Item
1
2
3
Tighten hardware to 16-20 in-lb (1.8-2.2 Nm).
Item
1
2
Page 14 of 34
Description
Increment Weight Guide Rod
Description
Nut, ¼" Nylock
Washer, Flat ¼" ID
Increment Weight Guide Rod
Description
Rear Shroud
Shroud Retainer
Qty.
2
Qty.
2
2
2
Qty.
1
8