Tensioning Cable - CYBEX Ion Series Assembly Instructions Manual

Tensioning Cable

Cable should have enough tension so it stays seated into the pulley but not so tight that it pulls the head plate off the weight plate
below it.
1. If the head plate has lifted, loosen the jam nuts at the terminations and loosen the threaded plugs a half turn until the head plate
comes to rest on the weight plate below. Check that the cable's threaded plugs are engaged at least 1/2" (12.7mm) at each
termination point.
SEATED HEAD PLATE
1. No gap
2. Ensure that the weight stack selector pin can fully engage into each weight plate.
Item
1
3. When proper thread engagement is reached, tighten jam nut to 20-25 FT-LBS (27.2 - 34.0 Nm) using a 24mm wrench.
Description
Weight Stack Selector Pin
1. Gap
2. Bayonet obstructing weight stack pin
Page 27 of 34
SUSPENDED HEAD PLATE
Qty.
1