Johnson Controls TEC3010 Installation Instructions Manual page 7

4. Reattach the thermostat controller cover to the mounting base (bottom side first).
IMPORTANT: Make sure you reattach the cover that corresponds to its correct base. The CPU board number
needs to match the base board number. Otherwise you will encounter an operation error after you reattach a
cover and base that do not belong together as shown in Figure 4. See Table 2 for TEC3000 model names and
code numbers.
Figure 4: Installing the Thermostat Controller Cover (Left) and Error Code Indicating Mismatched Boards
Table 2: TEC3000 Model Names and Code Numbers
Name Code Number Name
TEC3010 20
TEC3011 21
TEC3012 22
TEC3013 23
TEC3020 24
5. Use a 1/16 in. (1.5 mm) Allen wrench or Johnson Controls T-4000-119 Allen-Head Adjustment Tool (order
separately) to reinstall the security screw on the top of the thermostat controller cover. See Figure 2 for security
screw placement.
6. Remove the protective plastic cover sheet from the display.
IMPORTANT: If the display is dirty, gently wipe it clean with isopropyl alcohol or ethyl alcohol. Do not scrub
hard as to avoid damaging the surface. Do not use other cleaners such as water, ketones, and aromatic
solvents, as they may damage the polarizer.
TEC3000 Series Wireless Proportional Fan Coil and Individual Zone Thermostat Controllers with Dehumidification
(Right)
Code Number
TEC3021 25
TEC3022 26
TEC3023 27
TEC3030 28
TEC3031 29
Capability Installation Instructions
7
CPU Board Base Board