Setting The Local Schedule - Johnson Controls TEC3010 Installation Instructions Manual

3. Press Schedule Options.
4. Press Schedule Source and select Schedule (Local) or External (BAS).
5. Press to save and
This option is also exposed to the BAS through the point OCC-CONFIG. If BAS is configured as the occupancy
source, map the point NET-OCC in and write to that point in order to control the schedule remotely. If the supervisor
goes offline (as identified by the network icon going away on the home screen of the TEC), the control logic
automatically falls back to the local schedule as the occupancy source. If that schedule is not set, the default
occupancy is continuously occupied.

Setting the Local Schedule

A weekly occupancy schedule with up to four occupancy events for each day can be set locally on the TEC and
operate independently of a supervisor. To set the schedule:
1. See Selecting Schedule Source to ensure the schedule source is set to Local.
2. Press the Menu icon.
3. Press Schedule.
4. Press Set Schedule.
5. Select the days to which the schedule should apply. Note that if events are already set for the selected days,
they show in the corresponding event box. If any events conflict between selected days, an asterisk displays in
the event box. See Figure 15.
6. Select the event to be set. See Figure 15.
7. Set the Occupancy to Not Set, Occupied, Unoccupied, or Standby and press the Save icon. See Figure 16.
IMPORTANT: Internally, the TEC 3000 uses a BACnet-compliant schedule where daily schedules are
independent of the previous and next days. The default occupancy of the TEC3000 from the factory is set to
Occupied. As a result, a daily event at 12:00AM must be scheduled if the controller should not transition to
Occupied Mode at midnight.
Figure 15: Selecting the Days (Left) and Selecting the Event (Right)
TEC3000 Series Wireless Proportional Fan Coil and Individual Zone Thermostat Controllers with Dehumidification
to return to the previous screen.
Capability Installation Instructions
26