Ricoh 7650 Operating Instructions Manual page 59

❖ Ethernet Speed
Set the access speed for networks.
Select a speed that matches your network environment. [Auto Select] should
usually be selected.
The default setting is Auto Select.
❖ LAN Type
When you have installed the optional IEEE 802.11b interface unit, select inter-
face, IEEE 802.11b (wireless LAN) or Ethernet.
The default setting is Ethernet.
Appears when the IEEE 802.11b interface unit is installed.
If Ethernet and IEEE 802.11b (wireless LAN) are both connected to the ma-
chine, the selected interface takes precedence.
❖ Ping Command
Check the network connection with ping command using given IPv4 address.
If you fail to connect to the network, check the following, and then retry the
ping command.
• Check TCP/IP of the printer is active.
• Check that the machine with assigned IPv4 address is connected to the net-
work.
• There is a possibility that same IPv4 address is used for the specified
equipment.
❖ Permit SNMPv3 Communication
Set the encrypted communication of SNMPv3.
The default setting is Encryption / Clear Text.
If you set to [Encryption Only], you need to set password for the machine.
❖ Permit SSL / TLS Communication
Set the encrypted communication of SSL/TLS.
The default setting is Ciphertext / Clear Text.
If you set to [Ciphertext Only], you need to install the SSL certificate for the ma-
chine.
❖ Host Name
Specify the host name.
Enter the host name using up to 63 alphanumerical characters.
❖ Machine Name
Specify the machine name.
Enter the machine name using up to 31 alphanumerical characters.
Interface Settings
2
49