Oce 9300 User Manual page 32

Feed the material between the input guide plates against the rollers. Turn the
7
rollers until the material is visible (see figure 13). You can also refer to the
sticker inside the drawer.
[13] Feeding print media
If you have inserted a roll with another media or with a different width, you
8
have to program the correct width and media type (refer to 'Programming
media settings' on page 34).
If you want to cut the paper to get a straight leading edge, see 'Cutting print
media to attain a straight leading edge' on page 30.
Otherwise continue with the next step.
Close the lower paper compartment.
9
Press the 'Cancel/Continue' button.
10
32 Océ 9300 User Manual