Communication Protocol Setting; Transmission Speed Setting (Baud Rate Setting) - EverFocus EPTZ3150 User Manual

2.3.2. Communication Protocol Setting

st nd rd
The 1 , 2 and 3 bits are used to set communication protocol. The factory default
protocol is EVF.
Notice: If all protocol switches are set to ON, the EPTZ will enter a self-test mode.

2.3.3. Transmission Speed Setting (Baud Rate Setting)

th th
The 4 and 5 bits on the PCB board are used to set the Baud Rate. The default baud rate
setting is 9600.
23