Communication Protocol Setting; Transmission Speed Setting (Baud Rate Setting) - EverFocus EPTZ1000 User Manual

2.3.2. Communication Protocol Setting

st nd
The 1 , 2 and 3
default protocol is EVF-1.
Protocol
Baud Rate
PAL / NTSC
Maching Resistance
Notice: Please make sure the power is off before setting, and restart the EPTZ1000 to
enable a new value after changing.
Set all of protocol switches to ON; the speed EPTZ1000 will enter a self-test mode.

2.3.3. Transmission Speed Setting (Baud Rate Setting)

th th
The 4 and 5 bits of the SW2 on the PCB board are used to set the Baud Rate. The
default baud rate setting is 9600.
SW2
Protocol
Baud Rate
PAL / NTSC
Maching Resistance
Notice: Please make sure the power is off before setting, and restart the EPTZ1000 to
enable a new value after changing.
rd
bits of the SW2 are used to set communication protocol. The factory
EVF - 1
SW2
9600 BPS
PELCO-D
4800 BPS 2400 BPS
2-13
PELCO-P
1200 BPS