Communication Protocol Setting
st
nd
rd
The 1
, 2
and 3
bits are used to set communication protocol. The factory default protocol is
EVF.
Notice: Please make sure the power is off before setting, and restart the EPTZ860 to enable a
new value after changing.
Set all of protocol switches to ON; the speed dome EPTZ860 will enter a self-test mode.
Transmission Speed Setting (Baud Rate Setting)
th
th
The 4
and 5
bits on the PCB board are used to set the Baud Rate. The default baud rate setting
is 9600.
SW2
Protocol
Baud Rate
Terminal
Resistance
Notice: Please make sure the power is off before setting, and restart the EPTZ860 to enable a
new value after changing.
9600 BPS
4800 BPS
15
Analogue IR speed dome series
2400 BPS
1200 BPS