Connections; Initial Setup - EverFocus EPTZ3150 User Manual

2.2. Connections

Power Cable
An adapter with 24VAC/3.5A output provides the power to the EPTZ. An extension power
line may be needed.
Note: Different regions may use different ranges for AC voltage. Be sure to check the
voltage range in your area before installing.
Video Cable
A BNC cable is used for connecting an EPTZ to a DVR or a monitor. An amplifier may be
needed depending on the distance.
RS485 Cable
The yellow wire carries RS485+, and the orange wire carries RS485-. Connect these
wires to the EKB500 or other control device in order to control the PTZ camera.

2.3. Initial Setup

Initial setup includes dome address, communication protocol, transmission speed, and
terminal resistance settings. All of the settings should be confirmed before the dome is
powered up. The camera's control settings must match the ones in the control device
Yellow RS485+
Orange RS485-
VIDEO
24VAC
18