(such as a keyboard or DVR).
Notice: Please make sure the power is off while making changes. EPTZ must be restarted
before new values will take effect.
2.3.1. Address Setting
The address code of the EPTZ should be set to correspond properly with a control
device to control multiple dome cameras. The address is indicated by the dip switches
on the main camera body. The 8 switches correspond with the binary code of the
address, allowing up to 256 total addresses (0~255). It also means that there are up to
256 dome cameras that can cascade on the RS-485 bus. The dip switch setting and
the indicated address are represented in the following diagram.
Note: The factory default address is 1.
ON
1 2 3 4 5 6 7 8
Protocol/Baud rate
19
ON
1 2 3 4 5 6 7 8
ID address