Communication Protocol Setting; Transmission Speed Setting (Baud Rate Setting) - EverFocus EPTZ3000 User Manual

2.3.2. Communication Protocol Setting

st nd
The 1 , 2 and 3
factory default protocol is EVF.
Protocol
Baud Rate
Terminal
Resistance
Notice: Please make sure the power is off before setting, and restart the
EPTZ3000/EPTZ3000I to enable a new value after changing.
Set all of protocol switches to ON; the speed EPTZ3000/EPTZ3000I will enter a
self-test mode.

2.3.3. Transmission Speed Setting (Baud Rate Setting)

th th
The 4 and 5
default baud rate setting is 9600.
SW2
Protocol
Baud Rate
Terminal
Resistance
rd
bits of the SW2 are used to set communication protocol. The
EVF
SW2
bits of the SW2 on the PCB board are used to set the Baud Rate. The
9600 BPS
PELCO-D PELCO-P A-TYPE
4800 BPS
2-17
2400 BPS 1200 BPS