2.3.2. Communication Protocol Setting
st
nd
The 1
, 2
and 3
factory default protocol is EVF.
SW2
Protocol
Baud Rate
PAL / NTSC
Maching Resistance
Notice: Please make sure the power is off before setting, and restart the speed dome to
enable a new value after changing.
Set all of protocol switches to ON; the Outdoor/Indoor Speed Dome will enter a
self-test mode.
2.3.3. Transmission Speed Setting (Baud Rate Setting)
th
The 4
and 5
default baud rate setting is 9600.
SW2
Protocol
Baud Rate
PAL / NTSC
Maching Resistance
Notice: Please make sure the power is off before setting, and restart the speed dome to
enable a new value after changing.
rd
bits of the SW2 are used to set communication protocol. The
EVF - 1
th
bits of the SW2 on the PCB board are used to set the Baud Rate. The
9600 BPS
PELCO-D
4800 BPS
2-18
PELCO-P
TYPE-A
2400 BPS
1200 BPS