Communication Protocol Setting; Transmission Speed Setting (Baud Rate Setting) - EverFocus EPTZ2700 User Manual

2.3.2. Communication Protocol Setting

st nd rd
The 1 , 2 and 3
protocol is EVF.
Notice: Please make sure the power is off before setting, and restart the
EPTZ2700/EPTZ2700I to enable a new value after changing.
Set all of protocol switches to ON; the speed dome EPTZ2700/EPTZ2700I will
enter a self-test mode.

2.3.3. Transmission Speed Setting (Baud Rate Setting)

th th
The 4 and 5 bits on the PCB board are used to set the Baud Rate. The default baud rate
setting is 9600.
SW2
Protocol
Baud Rate
Terminal
Resistance
Notice: Please make sure the power is off before setting, and restart the
EPTZ2700/EPTZ2700I to enable a new value after changing.
bits are used to set communication protocol. The factory default
9600 BPS 4800 BPS
19
2400 BPS 1200 BPS