Table of Contents
Advertisement
CHAPTER
3. Installation and
Configuration
3
This chapter describes the steps for downloading, installing and configuring the CallConnector
Operator Standalone and Client. The following topics are discussed:
Installation Overview -
Pre-requisites for Installation -
Configurations on Router -
Minimum System Requirements -
Download Site -
Installing CallConnector Operator -
Configuring CallConnector Server -
Performing an Upgrading -
Removing CallConnector Operator - This section describes the steps for removing
Troubleshooting -
Provides an overview of the CallConnector
Operator client and standalone installation
process.
Describes the information you need to have on
hand during the installation of the CallConnector
Operator client and standalone.
Describes the features and services that need to
be setup on the Cisco Router for the
CallConnector Operator.
Describes the minimum hardware and software
required to run the CallConnector Operator.
Site from which the CallConnector Operator
software can be downloaded.
Describes the steps and options for installing
CallConnector Operator.
This section provides the steps for configuring
CallConnector Operator in Standalone mode. It
refers installers to the Administrator's Guide.
Describes the steps for upgrading an existing
CallConnector Operator with a new install
program.
and un-installing the CallConnector Operator
program and all its components.
Describes the steps for resolving installation and
configuration issues.
Advertisement
Table of Contents
