Gas Tubing For Bake Burner Removal - Viking VGIC530 Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Gas Tubing For Bake Burner Removal

Condition Requirements:
Back Panel Removed
Gas Supply Disconnected
Gas leak hazard. To avoid risk of personal injury
or death, leak testing of the appliance must
be conducted according to the manufacturer's
instructions. Before placing appliance in operation,
always check for gas leaks with soapy water solution.
DO NOT USE AN OPEN FLAME TO CHECK FOR
GAS LEAKS.
1. Remove burner grates, caps, bowls, and grate
support from right side of the range.
2. Remove screw and position burner assembly away
from cover.
3. Remove screws and cover from range.
©2010 Viking Preferred Service
4. Remove gas tube from solenoid valve.
5. Remove screws, bracket, and gas tube from range.
6. Remove nut and bracket from gas tube.
7. Reverse procedure for installation.
8. Perform gas leak test.
Disassembly
33