Door Hinge Removal; Temperature Sensor (Rtd) Removal; Bake Element Removal - Viking DSCD130 Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Door Hinge Removal

Condition Requirements:
Outer Door Panel Assembly Removed
1. Remove screws and hinge from inner door panel.
2. Remove screw and hinge support from hinge.
Note: Use care with insulation, make sure to replace
any damaged or missing insulation. Keep vent
on inner door panel clear of insulation.
3. Reverse procedure for installation.

Temperature Sensor (RTD) Removal

Condition Requirements:
Door Lowered
1. Remove screws that attach the sensor to the back of
the oven liner.
2. Pull the sensor connector into the oven cavity and
disconnect sensor connector.
Note: During install, it may be helpful to insert a small
screwdriver or awl into the connector and push
the wiring and connector into place.
3. Reverse procedure for installation.
©2010 Viking Preferred Service

Bake Element Removal

Condition Requirements:
Door Assembly Removed
1. Remove screws and lift kick plate from keyhole
screws.
2. Remove keyhole screws and lower access grill from
range.
3. Remove screws and bake tray cover from range.
4. Remove bake element insulation from range.
Note: Use care with insulation, make sure to replace
any damaged or missing insulation.
5. Remove screws and slide bake element tray forward
to gain access to connectors.
6. Mark and disconnect connectors from bake element.
7. Remove bake element from range.
8. Reverse procedure for installation.
Disassembly
25