Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Door Assembly Removal
Condition Requirements:
Door Lowered
1. Place pins supplied with unit in pin holes.
Note: For personal safety, only use pins supplied with
unit.
2. Remove screws and hinge trim from range.
3. Gently close door until pins stop door.
4. Lift door up and out.
Door Assembly
5. Reverse procedure for installation.
Note: If the door needs to be adjusted, loosen hinge
trim screws. Adjust the screws located between
the door and kick plate using a
allen wrench. Tighten hinge trim screws after
adjustment is made.
20
Door Gasket Removal
Condition Requirements:
Door Lowered
1. Insert a narrow tool or small flat-blade screwdriver
2. Remove the door gasket from two holes in the bottom
3. Reverse procedure for installation.
Adjustment Screw
5
/
" hex head
32
into the center of each clip and pry upward.
of the door liner.
©2010 Viking Preferred Service