Bake Burner Igniter Removal; Bake Burner Removal; Bake Burner Orifice Removal - Viking VGIC530 Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
4. Remove screws and bracket that secure inner glass
panel.
5. Lift inner glass from inner glass panel.
6. Remove black fiberglass rope from inner glass panel.
Note: Use care with insulation; make sure to replace
any damaged or missing insulation.
7. Reverse procedure for installation.

Bake Burner Igniter Removal

Condition Requirements:
Door Assembly Removed
1. Remove screws and lift kick plate from keyhole
screws.
2. Lift to remove oven cavity bottom panel from range.
©2010 Viking Preferred Service
3. Disconnect wire from igniter.
4. Remove screw and igniter from bake burner.
5. Reverse procedure for installation.

Bake Burner Removal

Condition Requirements:
Bake Burner Igniter Removed
1. Remove screws and bake burner from range.
2. Reverse procedure for installation.

Bake Burner Orifice Removal

Condition Requirements:
Bake Burner Removed
Note: Before removing orifice, secure gas tubing to
avoid bending or twisting of gas tubing.
1. Remove orifice from manifold.
2. Reverse procedure for installation.
Disassembly
23