Outer Door Glass Removal; Inner Door Glass Removal - Viking VGIC530 Service Manual

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Outer Door Glass Removal

Condition Requirements:
Outer Door Panel Assembly Removed
Door Handle Removed
1. Remove door insulation panel by sliding and turning
the panel until it clears the door skin.
2. Remove door skin insulation from door skin.
3. Remove window holder and outer door glass from
door skin.
Note: The window holder is secured with double-sided
tape. Use care when removing from door skin.
4. Remove outer door glass from window holder.
Note: The outer door glass is secured with double-
sided tape. Use care when removing from
window holder.
22
5. Remove J mold from door skin.
6. Reverse procedure for installation.

Inner Door Glass Removal

Condition Requirements:
Outer Door Panel Assembly Removed
1. Remove screws, brackets and door insulation
retainer from inner door panel.
2. Remove inner glass panel and door insulation from
inner door panel.
Note: Use care with insulation; make sure to replace
any damaged or missing insulation.
3. Remove screws and inner door panel from inner door
glass assembly.
©2010 Viking Preferred Service