Door Hinge Removal; Bake Burner Igniter Removal; Bake Burner Removal; Broil Burner And Igniter Removal - Viking RVGR3305B Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Door Hinge Removal

1. Remove outer door panel assembly (see Outer Door
Panel Assembly Removal).
2. Place the inner door panel assembly on a protected
surface.
3. Remove screws, nut, and hinge from inner door
panel.
4. Reverse procedure for installation.

Bake Burner Igniter Removal

1. Remove oven door (see Door Assembly Removal).
2. Remove screws and lift kick plate from keyhole
screws.
3. Lift to remove oven cavity bottom panel from range.
4. Disconnect wire from igniter.
5. Remove screw and igniter from bake burner.
©2013 Viking Preferred Service
6. Reverse procedure for installation.

Bake Burner Removal

1. Remove bake burner igniter (see Bake Burner Igniter
Removal).
2. Remove screws and bake burner from range.
3. Reverse procedure for installation.

Broil Burner and Igniter Removal

1. Remove oven door (see Door Assembly Removal).
2. Remove screws that secure broil burner to top of
oven cavity.
3. Carefully lower broil burner and pull igniter wire into
oven cavity.
4. Disconnect wire and then remove broil burner from
range.
5. Remove screw and igniter from broil burner.
(View of top of oven cavity)
Disassembly
23