Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Bake Element Removal
Condition Requirements:
Door Assembly Removed
1. Remove two screws and lift kick plate from keyhole
screws.
2. Remove two keyhole screws and lower access grill
from range.
3. Remove two screws and bake tray cover from range.
4. Remove bake element insulation from range.
Note: Use care with insulation, make sure to replace
any damaged or missing insulation.
32
5. Remove two screws and slide bake element tray
forward to gain access to connectors.
6. Mark and disconnect four connectors from bake
element.
7. Remove bake element from range.
8. Reverse procedure for installation.
Rack Support Removal
Condition Requirements:
Door Assembly Removed
1. Remove four screws and rack support from each side
of oven cavity.
2. Reverse procedure for installation.
©2009 Viking Preferred Service