Door Handle Removal; Inner Door Glass Removal - Viking DCCG130 Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Door Handle Removal

Condition Requirements:
Outer Door Panel Assembly Removed
1. Remove screws and handle assembly from outer
door panel assembly.
2. Remove screws and slide end caps from handle.
3. Reverse procedure for installation.

Inner Door Glass Removal

Condition Requirements:
Outer Door Panel Assembly Removed
1. Place the inner door panel assembly on a protected
surface.
2. Remove screws and bracket from inner door panel.
©2010 Viking Preferred Service
3. Remove screws, brackets and door insulation
retainer from inner door panel.
4. Remove inner glass panel and door insulation from
inner door panel.
Note: Use care with insulation; make sure to replace
any damaged or missing insulation.
5. Remove screws and inner door panel from inner door
glass assembly.
6. Lift inner glass from inner door panel.
7. Remove black fiberglass rope from inner door panel.
Note: Use care with insulation; make sure to replace
any damaged or missing insulation.
8. Reverse procedure for installation.
Disassembly
19