Door Handle Removal; Outer Door Panel Assembly Removal; Outer Door Glass Removal - Viking VGCC530 Service Manual

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Door Handle Removal

Condition Requirements:
Door Lowered
1. Remove two plugs from each side of door assembly.
2. Remove three screws from each door handle end
cap.
3. Pull end cap up then out to remove from handle.
4. Reverse procedure for installation.

Outer Door Panel Assembly Removal

Condition Requirements:
Door Assembly Removed
1. Place the door, handle side down, on a protected
surface.
2. Remove seven screws that attach the outer door
panel assembly to the inner door panel assembly.
20
3. Lift the inner door panel assembly from the outer
door panel assembly.
4. Reverse procedure for installation.

Outer Door Glass Removal

Condition Requirements:
Outer Door Panel Assembly Removed
Door Handle Removed
1. Remove four locknuts and door insulation bracket
from door insulation panel.
2. Remove door insulation panel by sliding toward the
bottom of the door skin.
3. Remove door skin insulation from door skin.
©2009 Viking Preferred Service