Tail Light Replacement; Interior Led Lights - Polaris General 2020 Service Manual

CHASSIS / BODY ELECTRICAL

TAIL LIGHT REPLACEMENT

SERVICE VIDEO
A service video has been created
to help highlight this procedure.
To view the video, either:
• Scan the QR Code with a
mobile device
• From a computer, right click
HERE and open link in a new
window.
Before replacing the taillight(s), use a digital multi-meter
to test the harness to ensure the lamp is receiving 12
Volts and that a ground path is present.
1. Lift the cargo box.
2. Remove the fastener holding the cargo box trim panel
to the cargo box and remove the panel.
3. Reaching through the access hole on the outside of
the cargo box, remove the fasteners holding the tail
light to the cargo box.
4. Remove the tail light from the cargo box and
disconnect the wire harness.
12.64
5. To install, reverse removal procedure. Torque tail light
fasteners to specification.
TORQUE
Tail Light Fasteners:
4 lb-ft (5 Nm)

INTERIOR LED LIGHTS

The vehicle is equipped with a 3 LED interior lights that
illuminate when the key is in the 'ACC' or 'ON' position.
International models: These LEDs illuminate when the
key has been switched on. They will stay on for
approximately 20 seconds after the key has been turned
off.
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.