Switch Service; Brake Pressure Switch - Polaris General 2020 Service Manual

SWITCH SERVICE

BRAKE PRESSURE SWITCH

q
The brake pressure switch
brake line banjo bolt of the master cylinder. The brake
switch may be accessed easily through the front LH
wheel well.
TESTING
1. Disconnect wire harness from switch and connect an
ohmmeter across switch contacts. The reading
should be infinite (OL).
2. Apply the brake and check for continuity. If there is no
continuity, or if resistance is greater than 0.5 ohms,
clean the switch terminals. Re-test and replace switch
if necessary.
SWITCH POSITION
Brake Pedal Released
Brake Pedal Pressed
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
is located on the front
CONTINUITY BETWEEN
No continuity between
pins
Continuity between pins
CHASSIS / BODY ELECTRICAL
REPLACEMENT
NOTICE
Brake fluid will leak out of the master cylinder when the
brake switch is replaced. Place a suitable catch
container/rags below the master cylinder prior to brake
switch removal.
1. Disconnect the harness going to the brake switch.
2. Loosen and remove the brake switch.
3. Install new brake switch. Torque brake switch to
specifications.
TORQUE
Brake Switch:
15 lb-ft (20 Nm)
4. Bleed the brake system. Refer to "Brake Bleeding /
Fluid Change page 10.7" procedure.
12
12.65