Tail Light / Brake Light; Led Lamp Replacement - Polaris RANGER 500 2017 Service Manual

Hide thumbs Also See for RANGER 500 2017:

Table of Contents

TAIL LIGHT / BRAKE LIGHT

1. From the rear of the LED lamp, remove the (2) T20

Torx-head screws

retaining the lamp assembly.

2. Remove the lamp from the cargo box and disconnect

the tail light / brake light wire harness.

Before replacing the LED lamp assembly, use a digital

multi-meter to test the harness to ensure the lamp is

receiving 12-14 DC volts and that a ground path is

present. Lamps can be bench tested by applying 12-14

volts directly, as the LED tail/brake lamp units are

internally regulated.

3. If the LED lamp does not function with power and

ground applied to the lamp directly, replace the lamp

assembly. Apply dielectric grease (PN 2871329) to

the new lamp connector terminals.

4. Reinstall the assembly by reversing this procedure.

5. Test after installation to verify proper function of tail,

brake, and turn signal lamps.

9850043 R01 - 2017-2021 RANGER 500 / 570 Service Manual

Table of Contents