Tail Light; Tail Light Lamp Replacement; Indicator Lamps; Indicator Lamp Replacement - Polaris RZR 170 2009 Service Manual

ELECTRICAL

TAIL LIGHT

Tail Light Lamp Replacement

If the tail light lamp does not work, the lamp may need to be
replaced.
1. Remove the two screws securing the lens cover. Remove
the lens cover.
2. Remove the lamp and replace it with a new recommended
lamp. Apply Dielectric Grease (PN 2871329) to the lamp
terminals.
3. Test the light for proper operation.
4. Reinstall the lens cover.
8.6

INDICATOR LAMPS

Indicator Lamp Replacement

1. The indicator lamps are located on the dash.
2. Disconnect the indicator light wire connections from the
harness.
3. Remove the nut from the backside of the indicator lamp.
4. Remove the lamp.
5. Install new lamp(s) into the dash and secure with retaining
nut.
6. Apply dielectric grease to the wire connections of the new
lamp.
7. Turn ignition key to the "ON" position and shift the
transmission into "Neutral" or "Reverse" to verify light
operation.
8. If the lights do not operate, check battery voltage at the light
harness and check related wiring for possible malfunction.