Tail Light Replacement; Dash Led Light - Polaris GENERAL 2016 Service Manual

Table of Contents

TAIL LIGHT REPLACEMENT

SERVICE VIDEO

A service video has been created

to help highlight this procedure.

To view the video, either:

• Scan the QR Code with a

mobile device

• From a computer, right click

HERE and open link in a new

Before replacing the taillight(s), use a digital multi-meter

to test the harness to ensure the lamp is receiving 12

Volts and that a ground path is present.

1. Lift the cargo box.

2. Remove the fastener holding the cargo box trim panel

to the cargo box and remove the panel.

3. Reaching through the access hole on the outside of

the cargo box, remove the fasteners holding the tail

light to the cargo box.

4. Remove the tail light from the cargo box and

disconnect the wire harness.

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

5. To install, reverse removal procedure. Torque tail light

fasteners to specification.

Tail Light Fasteners:

4 lb-ft (5 Nm)

The vehicle is equipped with an LED light below the dash

that illuminates when the key is turned on. This LED will

stay on for approximately 20 seconds after the key has

been turned off.

Table of Contents