Polaris General 2020 Service Manual page 326

PVT SYSTEM
4. Spin the compressor down until it just starts to
contact the helix cover. Remove the four screws
that secure the cam (helix) assembly using a T25
Torx driver.
The helix cover is loaded by the spring. Not using a
proper compressor may result in personal injury or
damage to the clutch.
5. Remove the universal clutch compressor.
6. Note the alignment of the X's
moveable sheave. Remove the spider assembly
and spring.
NOTICE
Spring is compression only and has no torsional wind.
6.26
CAUTION
w
on the spider and
7. Remove the E-clips
q y
rollers . Inspect the rollers for wear; replace if worn.
8. Press out the spring pins
e
9. Pull out the clutch slider pins
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
r t
, washers , and the clutch
u
in the inner sheave.
i o
and sliders
© Copyright Polaris Inc.
.