Polaris General 2020 Service Manual page 845

5. Disconnect Ride Command Display electrical
e
connectors .
6. Using fingers, carefully pull upper edge of console
rearward to detach four spring clips , then lift two
lower tabs out of slots.
7. Label and disconnect electrical harnesses from
switches, sockets, or other devices mounted to
console.
8. Detach main chassis harness connector
instrument cluster.
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
9. Remove two screws
assembly out of dash and set aside.
10. Remove the following fasteners:
• One push pin rivet
of dash.
• Two screws
• Two screws
• Two screws
11. Carefully pull the USB harness through the hole in the
glove box.
12. Detach slots
center console panels, then lift dash panel away from
support structure. Set panel aside.
r
from
Ensure the USB harness was pulled through the glove
box prior to fully removing the main dash panel from the
FACTORY-INSTALLED OPTIONS
t
, then lift instrument cluster
y u
and screw from each side
u
in glove box
u
forward of gear shift lever
u
forward of instrument cluster
i
in main dash panel from tabs in
NOTICE
vehicle.
13
13.49