Wireless Remote Controller - Daikin Aurora Series Service Manual

Main/Sub Setting
3.2

Wireless Remote Controller

Introduction
To set the wireless remote controller, you have to set the address for:
The receiver of the wireless remote controller
The wireless remote controller.
Setting the Address for the Receiver
The address for the receiver of the wireless remote controller is factory setting to 1. To change this setting,
proceed as follows:
Set the wireless address switch (SS2) on the PCB according to the table below.
Unit No.
Wireless address
switch (SS2)
When using both a wired and a wireless remote controller for 1 indoor unit, the wired controller should be set to
MAIN. Therefore, set the MAIN/SUB switch (SS1) of the receiver to SUB.
MAIN/SUB
MAIN/SUB
switch (SS1)
Setting the Address for the Wireless Remote Controller
The address for the wireless remote controller is factory setting to 1. To change this setting, proceed as follows:
1. Hold down the
least 4 seconds to get the Field setting mode.
(Indicated in the display area in the figure at right.)
2. Press the
Each time the button is pressed the display switches between A
and b.
3. Press the
1 2
Address can be set from 1 to 6, but set it to 1 ~ 3 and to same
address as the receiver. (The receiver does not work with
address 4 ~ 6.)
4. Press the
5. Hold down the
Field setting mode and return to the normal display.
33
No. 1 No. 2
MAIN SUB
S
S
M
M
button and the
button and select a multiple setting (A/b).
button or button to set the address.
3 4 5 6
button to enter the setting.
button for at least 1 second to quit the
No. 3
button for at
Mode
Address
Multiple
setting
SiUS341802E
3
2
4
1
5
Remote Controller