Fast Charge Setting - UNI-T UTL8500X Series User Manual

Programable DC Electronic Load User Manual
charge mode and return to the main measurement interface.
Note: The measured object needs to allow the external device to control the voltage
of the D+ and D- data leads; otherwise the measured object may be damaged.

5.7 Fast Charge Setting

Press the [System] key to enter the <System Configuration> interface, select the soft key
[Fast Charge Setting] at the bottom of the screen to enter the <Fast Charge Setting>
interface, and set the parameters such as the fast charge handshake/operation process to
achieve the best test effects.
Parameters in fast charge setting interface:
Parameters
QC initialization
Initial current
Wake-up current
PE trigger current
QC initial voltage
Figure 5-7 <Fast Charge Setting> Interface
Select QC initialization speed to adapt to different fast charging
sources, slow speed: better stability, fast: shorter initialization
time
Set the current value of the load after the QC handshake is
successful
Set the current value of continuous load after the end of the list
test
Set current value when PE trigger control
Set the initial voltage after successful QC handshake
Description
58