Pe2.0 Test - UNI-T UTL8500X Series User Manual

Programable DC Electronic Load User Manual
the ON button on the panel to load. After the load is successful, the ON button
indicator will turn green, the correct voltage and load value will be displayed on the
screen, and the OK symbol will be displayed on the upper right of the screen. Figure
5-4-2 shows the page after PPS 9V/1.000A is loaded.
4. The instrument defaults to CC mode as the main measurement interface. Users can
also use the soft key [Mode] to select other load modes (CV, CR or CP) and load
fixed value settings (such as Vset, Rset or Pset). After setting and entering the test,
press the ON button on the panel to load. Please refer to chapter 5.1 step 4 for
details.
5. In the test operating interface, users can see the operating process and result data,
such as Time, Vpp, etc.
6. After pressing the ON button on the panel, press the [EXIT] button to exit the fast
charge mode and return to the main measurement interface.

5.5 PE2.0 Test

Steps to enter the PE2.0 test interface:
1. Press the power button to turn on the electronic load. In the main measurement
interface (the default main measurement interface is CC mode when the instrument is
turned on), press the soft key [PE2.0] at the bottom of the screen to enter the <MTK
PE2.0> display interface. If it is not on the main measurement interface , users can
press the button [Mode], then select the soft key [Fast Charge] to enter the fast
charge horizontal bar selection interface, and finally enter the <MTK PE2.0> display
interface by pressing the soft key [PE2.0].
2. After entering the MTK PE2.0 mode interface, the electronic load will automatically
have a handshake with the measured object:
During the handshake/operating process, the indicator at the top right of the screen is
red, otherwise it is white.
If the handshake is successful, the status will be displayed as [OK], as shown in the
upper right corner of Figure 5-5, otherwise it will be displayed as [Err].
54