Invacare LiNX REM400 User's Manual Supplement page 94

LiNX® Control System
3. When in latched driving mode, puff soft into mouthpiece
to veer to the right.
4. When in latched driving mode, sip soft at mouthpiece
to veer to the left.
For more information about the calibration of hard
and soft inputs, refer to the service manual of the
LiNX system.
Stopping
A lipswitch B is mounted to the mouthpiece. This switch
can be used as an external stop switch, when in latched
driving mode. While you are in latched driving, you do not
need to give a drive input all the time, but the mouthpiece
must stay inside your mouth. As soon as the lipswitch is
pressed while driving, the wheelchair stops.
Changing function screens
The lipswitch can also be used as a mode function switch.
For difference between function screen and profile,
refer to 4.2.3 User function screen overview, page 17.
1. Stop wheelchair.
2. Short press lipswitch to change function screen.
3. Long press lipswitch to change profile.
Operating the lighting functions and horn
Via a utility function screen you are able to operate the
lighting functions with an external input. The utility function
screen is part of one or more profiles and can be activated
like a drive or seating function screen.
94
1.
Activate utility function screen.
2. Give input to front A to turn on horn.
3. Give short input to right B to turn on/off position lights.
4. Give short input to left C to turn on/off hazard lights.
5. Give long input to left or right D to turn on/off left
or right turn signal.
Activate a drive function screen to drive normally,
while position lights and hazard lights remain turned
on.
After more than ten seconds, the turn signals turn
off automatically.
60101834-C