Invacare LiNX REM400 User's Manual Supplement page 104

LiNX® Control System
Dip switch 11 & 12: Cursor movement options
F
3 switch 4 switch
G
OFF ON
A This is a slower speed initially for precise targeting. It
is set and used in conjunction with Cursor Delay to
give the user the ability to move the mouse slowly at
first and then speed up after a set amount of time to
move across the screen efficiently.
B This setting controls the maximum speed of the cursor
and is the speed that the mouse will obtain after
the initial speed. Note: The base speed is set in the
control panel of the computer's mouse settings.
C This is the initial amount of time the switch must
be pressed and held before the mouse speeds up.
This setting is used in conjunction with Initial Mouse
Movement and Maximum Cursor settings.
D This setting controls the amount of time the directional
switches must be activated before the cursor will
move. This is to allow for inadvertent switch closures.
Note: This applies to directional switches only.
104
4 switch 5 switch
E This setting controls the amount of time the Left and
Right Click switch must be held before it will latch.
Once the latch is no longer required, press the Right
Click or Left Click switch for the same length of time
to deactivate the latch.
F Switch 11 and 12 should be in the DOWN position
when using with the Head Array for 3 switch mouse
emulation.
G OFF: Original mouse speed, better for PC.
ON: Increases mouse speed by 1/3, better for MAC.
Numbers 0 to 6 describe the action the mouse should
perform. Letters A to F describe the direction of the input,
which leads to the mouse action.
Fig. 6-86
60101834-C