PRODUCT INSTALLATION MANUAL
Joining the Cases
Ensure cases are sealed before joining them to other cases
For instructions on attaching case ends, refer to appendix 4: attaching case ends
To join the cases
1. Draw up the required case tightly against the case already in position
2. Ensure that the case is level, from front to back and side to side, with the existing case.
3. Insert the joining bolts, found in the blister pack, into the end holes and tighten – see Fig (9): joining hole locations
_________________________________________________________________________________________________________________________
Page 11
CAUTION
Do not walk or sit on cases.
CAUTION
Case joining bolts should only be used,
with care, at the final pulling-up stage.
(9) Joining holes location
DC13 COLD PLATE
Joining Holes
Hussmann