Pre-Installation; Important Safety Instructions - Hussmann DC-1 Series Installation Manual

PRODUCT INSTALLATION MANUAL
Pre installation

Important Safety Instructions

Please read the user manual carefully and store for later reference. In this document you will see these symbols with
following meanings
WARNING
•
Leave enough space to install the system. The space requirement will be instructed in "Pre-installation" section.
•
Before installing the system make sure the power source is accessible to the cases array.
•
All the power source has to be properly earthed.
•
If any potential fail or product disconformity is investigated, please consult a qualified service technician.
•
Always disconnect the power of the cases before conducting any service or maintenance.
•
Keep the case out of direct sunlight, fire hazardous environment, or high moisture or humidity area.
•
Fail to install the system as instructed in this manual may void Hussmann Warranty.
REFRIGERANT WARNING
•
Refrigerant is not factory charged.
•
Default refrigerant is shown on the product rating plate and in engineering data sheets..
•
Ensure that during the transportation and installation the refrigerant circuit is not damaged. The Hussmann contact
details are at the front of this manual.
The installation should follow AS 5149, AS NZS 3000 or other local safety requirements.
_________________________________________________________________________________________________________________________
Page 2
NOTE
Information in this manual is to be followed
in conjunction with specifications, work
practices and regulations of the customer,
installing company and relevant industry.
CAUTION
Care must be taken to avoid damage to
drainage outlets and electrical equipment
mounted under or at the rear of cases.
CAUTION
This symbol indicates electrical safety must
be concerned
DC13 COLD PLATE
Hussmann