Table of Contents
Advertisement
Installation (cont'd)
Setting and Joining
The sectional construction of these models enable them
to be joined in line to give the effect of one continuous
display.
Bolting locations which join like cases together are
displayed below.
Leveling
IMPORTANT! IT IS IMPERATIVE THAT CASES BE
LEVELED FROM FRONT TO BACK AND SIDE TO SIDE
PRIOR TO JOINING. A LEVEL CASE IS NECESSARY
TO INSURE PROPER OPERATION, WATER DRAINAGE,
GLASS ALIGNMENT AND OPERATION OF THE
HINGES SUPPORTING THE GLASS. LEVELING
THE CASE CORRECTLY WILL SOLVE MOST HINGE
OPERATION PROBLEMS.
CASE BOLTING
LOCATION
SILICONE
SEALANT AREA
1. Using case blueprints, measure off and mark on the
floor the exact dimensions of where the cases will sit.
Snap chalk line for front and back positions of base rail or
pedestal. Mark the location of each joint front and back.
Find the highest point throughout the lineup. FLOORS
ARE NORMALLY NOT LEVEL! Determine the highest
point of the floor; cases will be set off this point. All cases
in the entire lineup must be brought up to the highest level
of the case sitting at the highest point in the lineup.
2. Set first case over the highest part of the floor and
adjust legs so that case is level.
15
Advertisement
Table of Contents
