Attaching Kickplates - Hussmann DC-1 Series Installation Manual

PRODUCT INSTALLATION MANUAL

Attaching Kickplates

(This should be done after final Installation of Refrigeration and Drainage connections)
Attach kickplates and, if required, silicon seal to the floor once installation is complete and drains checked for water leaks.
Front Panel
1. Attached front panel and align with front skid rail refer figure 12.
2. Push front panel into bottom and top clips.
3. Check front panel is securely in position.
Back Panel
1. Attached back panel and align with back skid rail refer figure 13.
2. Push back panel into bottom clip and over top clips.
3. Check back panel is securely in position.
_________________________________________________________________________________________________________________________
Page 14
Fig (12) Attached front panel
Fig (13) Attached back panel
DC13 COLD PLATE
Hussmann