Hard-Disk Drives; Figure 4-8. Hard-Disk Drive Carrier Removal - Dell 6100 Service Manual

Dell poweredge 6100 servers: service manual
Hide thumbs Also See for 6100:
Table of Contents

Advertisement

Hard-Disk Drives

Figure 4-8. Hard-Disk Drive Carrier Removal

The hard-disk drives are mounted inside a hard-disk drive carrier. The hard-disk
drive carrier must be removed before a hard-disk drive can be removed. To
remove a hard-disk drive, follow these steps.
NOTE: Wait 20 seconds for the hard-disk drive to spin down before removing
the hard-disk drive carrier.
CAUTION: Hard-disk drives can be removed with the power on only if a
PowerEdge Expandable RAID Controller host adapter card is installed.
Otherwise, loss of data can occur.
1. If a PowerEdge Expandable RAID Controller host adapter card is
installed in the computer, wait until the three hard-disk drive indicators
are off, and then proceed to step 2. If this host adapter card is not
installed in the computer, turn off the system before proceeding to
step 2.
Refer to Chapter 6, "Installing SCSI Hard-Disk Drives," in the User's Guide
for more information.
2. Release the carrier by pulling down on the plastic drive handle.
3. Slide the drive carrier toward the front of the computer until it is free of
the drive bay.
4. Turn the drive carrier over, and place it on a flat work surface.
drive bay
plastic drive handle
Removing and Replacing Parts
4-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Poweredge 6100/200

Table of Contents