Servicing The Hard Disk Drives And Power Supply; References - Dell PowerEdge R320 Planning, Installation And Service Manual

Chapter 5 - Servicing
3. Place the VGA port saver on the LCNP4E (51405098-100) MAU connector and thread the VGA
port saver screw-locks into the LCNP4E MAU connector.
4. Place the MAU cable (51305380-100) on the Port saver and thread the MAU Cable Jack screw into
the screw-locks on the VGA Port Saver.
5.2

Servicing the hard disk drives and power supply

The server from Honeywell is configured with five 146 GB or 300 GB SAS hard drives for RAID-5
configuration and the fifth hard drive is a hot spare. The configuration also contains redundant power
supplies. Both the hard disk drives and power supplies are hot swappable and must be of same
capacity and speed. You must replace only one power supply and/or hard disk drive at a time in a
system that is turned on. Refer to the Dell documentation for detailed instructions on swapping the
power supply and hard disk drive.
5.2.1

References

The following table lists the specific Dell publications and relevant sections for troubleshooting and
servicing the hard disk drives and power supplies.
- 48 -